The ST-Link LD1 should light up, and the USB drive “NODE_L476RG” is mounted on the desktop. Connect the USB port to the ST-Link interface.When the ST-Link cable is connected to the target application, continue as follows: Another option is to break off the ST-Link part (see white dotted line in the Nucleo board figure above). Using the RX/TX/RST/SWO lines between a remote target and the Nucleo board ST-Link interface requires desoldering the 0 Ω bridges on the underside of the Nucleo board (see figure below). Preparation and connection of the adapter cableĪn 8-pin adapter cable acts as an ST-Link cable and is required to connect the Nucleo board to the target: Signalĭebug connector, VDD is not needed and may result in reverse current, therefore leave it open
0 Comments
Leave a Reply. |